News

How To Reduce Wear Of The Mixing Device Of A Double Ribbon Blender

May 08, 2026 Leave a message

1. Wear-Resistant Treatment for Ribbons

Hardfacing on Edges: Deposit hard alloys (e.g., high-chromium, tungsten carbide) on the outer edges and wall-contacting surfaces of inner/outer ribbons. This boosts abrasion resistance by 3–5× for hard materials (e.g., slag, quartz sand).

Thickened Base Material: Use thicker, high-grade steel (e.g., Hardox) for ribbon fabrication to resist thinning.

Removable Wear Strips: Bolt replaceable high-manganese or chromium-carbide plates on ribbon exteriors for easy maintenance.

Thermal Spraying: Apply tungsten carbide or Stellite coatings via HVOF to enhance surface hardness.

2. Protection for Main Shaft & Joints

Reinforce Weld Roots: Add wear-resistant weld layers at ribbon-to-shaft junctions to prevent cracking.

Hardened Shaft Sleeves: Install tungsten carbide or Stellite sleeves at seal zones to reduce journal wear.

Air-Purge Seals: Use gland seals with 10–15 psi compressed air to repel particles from stuffing boxes.

3. Liner & Trough Wear Control

Replaceable Liners: Line trough walls/bottoms with bolted high-manganese or chromium-carbide plates to isolate abrasion.

Welded Grid Patterns: Hardface trough interiors with a crisscross weld pattern to resist erosion.

Precise Gap Control: Maintain 3–5 mm gap between ribbons and liners to avoid material trapping or scraping.

4. Process & Operational Optimization

Lower Peripheral Speed: Reduce ribbon tip speed (typically 1.5–2.5 m/s) to minimize friction intensity.

Foreign Object Removal: Install inlet grilles to exclude metal/scrap that causes impact damage.

Material Preprocessing: Screen or crush oversized/hard particles; control moisture to prevent adhesion.

Avoid Overloading: Operate at 70–80% capacity to reduce torque and contact pressure.

5. Preventive Maintenance Schedule

Daily: Inspect ribbons for bending/cracking; check seals for leakage; listen for abnormal noises.

Monthly: Measure ribbon thickness (replace if worn > 1/3 original); verify bolt tightness.

Quarterly: Realign shaft; inspect gearbox oil; clean trough thoroughly.

Annual: Rebuild worn components; reapply hardfacing coatings.

Advantages Of The Large-opening Discharge Door Of Twin-shaft Mixer

Send Inquiry