Mixing blades and arms: Residues often adhere to blade surfaces and shaft connections. Wire brushes and high-pressure water guns are needed to clean the gaps thoroughly.
Mixing drum inner wall: Hardened materials easily stick to the bottom and the area near the discharge port. They should be gently removed with a chisel and then rinsed.
Discharge gate and chute: Material accumulation here may cause blockages and affect discharging. Shovels or brushes can be used to clear residues.
Shaft end seals: Rubber gaskets and other seals should be wiped gently with a damp cloth. Direct high-pressure water impact or hard tool scraping is forbidden to avoid damage.
Feed inlet: Dust and materials tend to accumulate at the inlet, requiring regular cleaning to prevent contamination of fresh materials.
