Cleaning Work
Cleaning Internal Materials: Before shutting down the machine, drain all the materials in the mixer. Then add an appropriate amount of water and stir for cleaning to remove the residual materials in the mixing drum. For stubborn materials adhered to parts such as the mixing blades and the drum wall, use tools to clean them carefully to avoid damaging the equipment surface.
Cleaning External Dust: Use tools like brooms and rags to remove dust, oil stains, and debris from the outside of the equipment, keeping the appearance of the equipment clean. For some hard - to - clean oil stains, special cleaning agents can be used for wiping.
Lubrication Maintenance
Inspecting Lubrication Parts: Check all the lubrication points of the mixer, including bearings, gears, chains, couplings, etc. Check whether the lubricating oil is sufficient and whether the oil quality is good.
Replenishing or Replacing Lubricating Oil: According to the inspection results, replenish or replace the lubricating oil in a timely manner. For equipment that has not been used for a long time, it is recommended to replace it with new lubricating oil to ensure the lubrication effect. When adding lubricating oil, add it according to the type and quantity of oil specified in the equipment manual.

Component Inspection and Maintenance
Inspecting Mixing Blades: Carefully check the wear condition of the mixing blades. If there are blades with severe wear or deformation, replace or repair them in a timely manner. At the same time, check whether the fixing bolts of the blades are loose, and tighten them if they are loose.
Inspecting Transmission Components: Check the tension of the belts and chains. Adjust them if they are loose. Check whether the belts and chains have wear, cracks, or other damage. Replace them in time if there is damage. In addition, check whether the connection bolts of the coupling are tight and whether the elastic elements are aging and damaged.
Inspecting the Electrical System: Check whether the electrical components in the electrical control cabinet are damaged, loose, or oxidized. Repair or replace them in time if there are problems. Clean the dust in the control cabinet to ensure good heat dissipation of the electrical system. Disconnect the power switch and take moisture - proof measures for the electrical system, such as placing desiccants.
Rust - proof Treatment
Protecting Metal Components: For the metal components of the equipment, such as the mixing drum, brackets, blades, etc., anti - rust treatment can be carried out by applying anti - rust oil, painting, etc. Before applying anti - rust oil, clean the metal surface to ensure that the anti - rust oil can adhere fully.
Preventing Rust - prone Environments: Try to store the equipment in a dry and ventilated indoor environment to avoid exposing the equipment to humid and corrosive environments. If this is not possible and the equipment needs to be stored outdoors, cover the equipment with a waterproof canvas to prevent rainwater, moisture, etc. from eroding the equipment.
