News

Reasons And Solutions For The Non-rotation Of The Mixing Shaft Of A Concrete Mixer

May 21, 2025 Leave a message

Power Supply or Motor Issues

Possible Causes:

No Power Supply: Circuit breakers tripped, fuse blown, or loose wiring.

Motor Failure: Burned-out motor windings, faulty start/run capacitors (for single-phase motors), or mechanical damage to the motor.

Overload Protection Triggered: Motor overheats due to excessive load, causing thermal overload switches to trip.

Solutions:

Check the power source: Reset circuit breakers, replace fuses, and inspect wiring connections for looseness or damage.

Test the motor with a multimeter to check for continuity in windings or capacitor functionality. Replace faulty components or the entire motor if necessary.

Reduce the mixing load (e.g., avoid overfilling the mixer) and reset the overload protector after cooling.

Maintenance Of The Shaft - End Seal Of A Twin - Shaft Mixer Is Crucial For Its Normal Operation And Service Life

Mechanical Blockages or Jams

Possible Causes:

Material Build-up: Concrete residue or foreign objects (e.g., tools, rocks) stuck between the shaft, blades, or mixer drum.

Belt or Chain Slackness: Worn-out or loose drive belts/chains (common in belt-driven systems) causing slippage.

Gearbox Failure: Damaged gears, lack of lubrication, or gear oil contamination in the transmission system.

Solutions:

Power off the mixer and manually inspect the drum/shaft for blockages. Use a scraper or brush to remove hardened concrete and remove foreign objects.

Tighten or replace loose/worn belts/chains. Ensure proper alignment of pulleys/sprockets.

Check gearbox oil levels and quality. Replace oil if contaminated, and repair or replace damaged gears.

Control System Malfunctions

Possible Causes:

Faulty Switches or Relays: Start/stop buttons, limit switches, or control relays stuck or damaged.

Wiring Issues: Loose, corroded, or disconnected wires in the control panel.

PLC or Controller Errors: Programming faults or hardware failures in automated control systems.

Solutions:

Test switches and relays with a multimeter. Replace defective components (e.g., buttons, relays).

Inspect and reterminate loose wiring connections. Replace corroded or damaged cables.

For PLC systems, check error codes and reset the controller if needed. Reprogram or replace the controller if software/hardware faults persist.

Bearing or Shaft Damage

Possible Causes:

Worn Bearings: Lack of lubrication, excessive load, or contamination leading to bearing seizure or wear.

Bent or Broken Shaft: Mechanical stress from overloading or impact causing shaft misalignment or fracture.

Solutions:

Lubricate bearings according to the manufacturer's schedule. Replace seized or noisy bearings, ensuring proper alignment during installation.

Inspect the shaft for visible damage (e.g., bends, cracks). Replace the shaft if damaged, and check for underlying causes (e.g., misalignment) to prevent recurrence.

Send Inquiry